Hello and welcome back to another Peachy tutorial!

Todays tutorial is very simple and I would rate it a beginners tutorial for those who are only just starting out with wired!

1. Double click your "Wired Effect: Show Message" and write in the message you'd like displayed when a user enters your room. Set the delay effect time to whatever you like! I usually set it between 1-2 seconds to allow people to load into the room.

2. Stack your wired and you're done! You can add to this by stacking another "Wired Effect: Show Message" on top with a different message, just set the delay times apart so the messages don't overlap! 

Thank you for following another Peachy tutorial and I hope I've made your life of wired a bit easier!